For clear skinz or printed skinz
For best results you will require the below
Spray Bottle filled with water and a drop or two of detergent
Isopropyl Alcohol (available in store)
A squeegee
Heat gun or hair dryer
Please ensure plastics are meticulously clean and free from any grease/oil residue, even if plastics
are brand new please still wiper over with isopropyl alcohol this will remove any oils on top of the plastics.
Ensure hands are clean and separate the section from the backing. Lightly mist with soapy water both the plastics
and the skinz. Place the graphic onto the plastics, the soapy water will allow some movement to align correctly.
Once aligned use either a squeegee or similar to put force on the skinz (best to work from the centre out) to remove air pockets and activate the adhesive. The adhesive is pressure sensitive so a good bit of force is best. For difficult areas you can heat the skinz gently in order to make more malleable. Please only run the heat over gently until soft enough to manipulate. Over HEATING may cause the skinz to melt.
Templates are based on stock plastics, aftermarket plastics may require some trimming of the Skinz.
REMOVING SKINZ
Skinz can easily be removed by applying heat either with a heat gun or hairdryer generally the skinz will come off without leaving any glue residue